Teledyne O3 Uživatelský manuál stáhnout pdf (Strana 63)

Teledyne API Model 401 O

Photometric Calibrator Instruction Manual, 01124, Rev. J2

To do a remote adjustment via the RS-232 interface, the host computer should issue a message

with the following format:

"C COMMAND<CRLF>"

The commands are summarized in Table 7-4.

Table 7-4: Control Commands

Command Message Meaning

"C ZERO<CRLF>" Do a zero check

"C O

GEN<CRLF>" Do a span check

"C ASEQ<CRLF>" Do a multi-point check

"C STBY<CRLF>" Exit zero, span, or ASEQ

NOTE

The commands in Table 7-4 can only be entered via the RS-232 port

when the calibrator is in the stand by mode. "C ASEQ" is enabled

only if ASEQ is pre-selected.

When a control command is issued, the CPU will respond by issuing a status report. For example

if the host computer issues the command:

"C ZERO<CRLF>"

to do a zero check, the CPU will send the report:

"C DDD:HH:MM IIII GENERATE ZERO"

to the RS-232 output.

7-5

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 113 114

Žádné komentáře

Teledyne O3 Uživatelský manuál Strana 63